Functional description
32
03.00 | RSS R1/W1 | Assembly and Operating Manual | en | 0889125
6.1.15 Manual setting of transmitter ID (programming)
If DIP 3 and DIP 4 are activated at the same time in the INACTIVE
status, the switching actuator is set in the programming mode.
When setting the first ID byte (ID0), the LC-LED flashes red (incl.
output) with 0.5 Hz for 10 s. After this, the LC-LED illuminates for 2
s to assume the DIP combination
The ID bytes 1, 2 and 3 are entered in the same way, whereby the
LC-LED illuminates for 10 s at the end (adoption ID3), in order to
have sufficient time to set the output DIP combination.
Example ID: 00 | 00| 09 | 88 = 00000000 | 00000000 | 00001001 |
10001000
ID3 ID2 ID1 ID0
DIP 1|2|3|4|5|6|7|8
NOTE
When teaching in the sequence of ID0... Observe ID3.
6.1.16 Output behaviour of the watchdog
Operating mode
Possible cause
Behaviour (Output
S)
LED
Operation
Watchdog addressed
Output LOW
On
Watchdog not addressed
Output HIGH
Off
Learning
Output LOW
On
Inactive
Output LOW
On
6.1.17 Software block diagram
