SCHUNK GSM-P 32, Сборка и руководство по эксплуатации

Страница: 43 / 60

Maintenance
8.5 Disassembly/assembly of the unit in the basic modules
Position of the item numbers, Drawings [ } 52]
Disassembly
1. Remove the compressed air lines.
2. Turn the gripping module (GSM) into the middle position.
3. Remove the screws (104) and pull the feed-through compact
module DKM (40) off the rotor drive FAN (50).
Assembly
1. Turn the rectangular section of the rotor drive (53) with the
longer side towards the center of the air connections A and B.
2. Turn the stop 1 DKM (81) with the magnet towards the 90°
position, i.e. with the 090 version, one magnet has to point
towards the 90° position and the other one towards the 180°
position.
3. Put the feed-through compact module DKM (40) on the rotor
drive FAN (50) and secure the two modules with the screws
(104). Observe permissible tightening torques,
Screw
tightening torques [
}
42].
8.6 Disassembly/assembly of the gripping module
WARNING
Risk of injury due to spring forces on variants with maintenance
of gripping force
With the "O.D. gripping" version, the bushing (46) or cover
housing (35) is under spring tension.
With the "I.D. gripping" version, the piston (36) is under spring
tension.
CAUTION
The needle rollers are suitable only for this product and cannot
be replaced with needle rollers belonging to another product of
the same type and size.
For assembly, observe the permissible tightening torques as well
as the greases and adhesives to be used,
Screw tightening torques
[
}
42] and Grease/greasing areas [
}
41].
43 11.00 | GSM-P | Assembly and Operating Manual | en | 389104