SCHUNK 1487754, Сборка и руководство по эксплуатации

Страница: 20 / 40

Start of Operations
20 01 | Matrix-Plate SMPL | Assembly- and Operating Manual | en-US | 0489081
CAUTION
Risk of crushing if the suction cup is abruptly attached to a
workpiece
•
Do not place any body parts between the suction cup and the
workpiece
7.3 Preparations for Picking up the Workpiece
7.3.1 Side Stops
The side stops consist of a set screw (not shown), stop (1) and
knurled nut (2) and are mounted as follows:
1. Screw the set screw into any M6 thread on the Matrix-Plate and
hand-tighten.
2. Attach the stop (1).
3. Screw the knurled nut (2) onto the set screw.
The stops can be raised or folded down as required.
1
2
The stops have two functions:
• Positioning aid for aligning the workpiece
• Absorbing horizontal lateral forces when machining the
workpiece.
We recommend having the stops raised up during machining.
Note:
When machining a workpiece, make sure that the chipping forces
act in the direction of the side stops.
If a stop is located in the collision area, it must be folded down or
removed to protect it from damage.
NOTICE
Metal chips and dirt between the stop and the Matrix-Plate
Contamination can affect the position of the workpiece zero
point.
•
Check that the space between the stop and the Matrix-Plate is
clear before each clamping process.