Maintenance
1/4" – 9/32" (6.35 – 7.1 mm) double open-ended wrench
FDB-300/-340
FDB 300/ FDB 340 series, flat collar
Replacement motor
7/16" [11 mm] open-end wrench
9/16” [14.5 mm] open-end wrench
8.2 Preventive Maintenance
The FDB is designed to provide a long life with few parts requiring
regular maintenance. The preventive maintenance of the
deburring tool consists of cleaning the unit and regular inspection
for wear or damage of the pneumatic lines, filter element, spindle
boot, and burr. Refer to
and Service Procedures to assist
the user when they choose to service the unit in the field.
8.2.1 Inspect Pneumatics Lines and Filter Regulator
The air lines to the FDB should routinely be checked for their
general condition and replaced as required. The air to the FDB
must be filtered, dry, and non-lubricated. The air filters should be
checked and replaced as required to maintain optimum
performance. The life of the filter elements is dependent on the
quality of compressed air at the customer’s facility and therefore
cannot be estimated.
8.2.2 Lubrication
Lubrication systems are not to be used.
The FDB air motor must
be supplied with clean, dry, filtered air. Oil in the air stream will
cause the air motor to fail prematurely. Failure of the motor due
to oil in the air stream is not covered under the warranty.
See
for details on air supply and quality.
CAUTION
Oil in the air stream will result in the premature failure of the
air motor and is not covered under warranty.
It is recommended that the customer use a coalescing filter and
filter elements rated 5 micron or better.
•
DO NOT use lubricated air with the FDB
8.2.2.1 Pneumatics
The air tubing/lines to the FDB should routinely be checked for
their general condition and replaced as required. The air to the
FDB must be filtered, dry, and non-lubricated. The air filters should
be checked and replaced as required to maintain optimum
33
04.00 | FDB | Assembly and Operating Manual | en | 389072