21
fig. 3.5.3d
Numerical Display
fig. 3.5.3e
Display with bargraph
fig. 3.5.3f
Graphical Display
3.5.3 Inserting and removing material to be measured (cont.)
Press the and button simultaneously to change the different display modes
during the working mode.
Do not let the thumbpiece snap back as this could affect the calibration and
damage the instrument.
While measuring the thumbwheel of the material thickness compensator
must be set to the measurement position, so that the material diameter is not
altered inadvertently.
If you rotate the thumbwheel while the thumbpiece is in position 2
(measuring position), the reading on the display will be updated, but the
value will not be used by the instrument to determine the tension – false
measurement!
To remove the material to be measured:
- Push the thumbpiece in the direction of the arrow into its threading position (1)
(Fig 3.5.3b).
- Remove the material to be measured.
-
Slowly
set back the thumbpiece into the adjustment position (0) (Fig. 3.5.3b).
