3 Assembly and start-up
14
SCHMIDT
®
ElectricPress 343-345
– V2.1
The working height depends on the height of the upper or lower tool used,
on the total stroke as well as on the height of the work piece to be
processed.
The press head is connected to the frame via a dovetail guide and clamping
screws.
Loosen the locking screws.
Use the height adjustment crank to set the desired working height.
Tighten the clamping screws with a torque of 60 Nm.
Figure 7: Adjusting the working height (example)
1
Display for working height (optional)
2
Height adjustment
3
Locking screws
For simple adjustment of the working height, a scale (material no. 546165)
can be mounted optional. The scale is in "mm" and shows the height of the
lower edge of the ram relating to the fixture mounting plate.
Adjusting the working stroke
The individual parameters of the working stroke are defined in the control
unit.
For further information, refer to the "Instructions for Use - SCHMIDT Manual
workstation"
respectively
the
"Assembly
Instructions
-
SCHMIDT
Components for automation".
3.6 Connecting the press
DANGER
Injuries or death caused by touching live parts
When carrying out assembly and maintenance work, you may come into
contact with parts that carry dangerous voltage during operation. Touching
live parts may cause death.
Any work on the electrical system or equipment must be carried out
only by trained electricians or by specially instructed persons under the
control and supervision of a trained electrician and in accordance with
the applicable electrical engineering rules and regulations.
Scale working height
(optional)
