3 Assembly and start-up
SCHMIDT
®
ElectricPress 343-345
– V2.1
13
For frames with a screwed fixture mounting plate, the fixture mounting plate
is aligned with the ram but not pinned.
3.5 Adjusting the working area
Constructive restrictions
CAUTION
Damage of the press or tool
The available working stroke is limited by the reference run. During a
reference run, a stroke is performed during which the uppermost position is
not reached by up to 3 mm.
Make sure that there is no collision between the tool and the press
head when performing a reference run.
The ram extension at home position corresponds to the topmost position,
reached after referencing.
Figure 6: Restrictions of the working stroke (example)
Press
343
345
1 Ram extension at home position
[mm]
20
28
2 Stroke during a reference run
[mm]
- 3
- 3
Adjusting the working height
CAUTION
Risk of crushing when adjusting the working height
If the locking screws are not tightened, the height adjustment will be
seriously damaged and there is a high risk of crushing when adjusting the
working height.
Firmly tighten the locking screws before the first test stroke.
Ensure the correct functioning of the height adjustment.
Ram extension at home
position
