schmalenberger fluvo LuchsNT, Руководство оператора

Страница: 9 / 24

OPERATOR'S MANUAL
LuchsNT
Version: 27142-A.1
Subject to technical changes
Schmalenberger GmbH + Co. KG
D-72072 Tübingen / Germany
9
Position 7 is unassigned.
Position 8 defines the termination of the DMX bus.
Function Pos.8 Note
DMX terminating resistor
active ON Device identified as BUS terminal device
DMX terminating resistor
inactive OFF
3.6 "Analog" control terminal

Used to control the light intensity.

The control function is always active for the LED-white control unit

Or for the RGB control unit in operating mode

Analog

Piezo
The standard signal input 0...10V has the following connection terminals:
10V Power supply voltage for potentiometer
IN
Signal input

GND
Note:

Min. potentiometer resistance value 1 k

-
typically 100 k

(optional accessories)

A defined signal must be present at signal
input IN.

Delivery condition: Wire jumper between IN
and 10V
3.7 "DMX" control terminal
+ Line "A" or "+"
– Line "B" or „–“

GND / shield
DMX signal display
LED
If the LED lights up, a DMX signal is
present at the input
Note:

The interface is electrically isolated

For the bus installation, shielded cables twisted in pairs must be used. E.g. CAT6
network cable

Ensure that the polarity of the bus connection is correct