Schleuniger CrimpCenter 64 SP, Оригинальное руководство по эксплуатации

Страница: 161 / 346

8. Commissioning
Original Operating Manual | Edition 1.0 (01-2020) | CrimpCenter 64 SP
161 | 268
Straightening Unit - Setup
Here we show you how to set the individual straightening units correctly.
Caution
The following settings must be performed one by one for each straightening unit.
Notice
It is very important that you set up the straightening units carefully. This is the best way to
ensure that the wire is optimally prepared for further processing.
1
3
2
4
5
Fig. 76: Straightening Unit - Slightly opened
2
6
Fig. 77: Straightening Unit - Closed
1.
▹
Open the straightening unit on the quick release (1).
2.
▹
Guide the wire over the straightening rollers through the straightening unit.
3.
▹
Close the straightening unit on the quick release (1).
4.
▹
Increase the distance (angle) on the left side with the knob (2).
➥
The left-hand straightening rollers (4) must not touch the cable.
5.
▹
Reduce the distance (angle) on the right side with the knob (3).
➥
The two right-hand straightening rollers (5) may just touch the cable in this way.
Notice
These settings must be carried out for every order.
6.
▹
Reduce the distance (angle) on the left side with the knob (2).
➥
The left straightening rollers (6) should easily walk the line.