Schleuniger CoaxCenter 6000, Справочное руководство

Страница: 103 / 194

9. Configuration settings
Reference Manual |Edition 5.0 (09-2016) | CoaxCenter 6000
103 | 194
Rotary incising unit:
■
Calibrate...:
The calibration of the unit itself is carried out via a wizard, see chapter "13.4.2 Calibra-
tion rotary incising unit (Page 138)" .
■
Swivel arm angle [°]:
Angle of the rotary incising unit to the swivel arm.
■
PushPull position:
The cutting mechanism of the rotary blades must depending on the cable
type, be calibrated. For this a special calibration wire AWG 36 is loaded. This wire is produced and
analyzed in the Q-cam. The measured length of the stripped inner conductor then is compared
with the programmed one. If the produced wire is too long, the calibrated value must be reduced
by the difference of the measured value to the set value. The result is entered manually into the
field "PushPull".
Feeding unit
■
No settings yet.
Swivel arm unit
■
Calibrate...:
The calibration of the swivel arm unit is carried out via a wizard, see chapter "13.4.3
Calibration swivel arm unit (Page 143)" .