24
/
33
5.3. Mounting the module-bearing rail (purlin)
Hammer in the fastening device
using a plastic tip hammer. Hold
a hammer against the other
side of the fastening plate for
stabilization reasons.
Fig. 5.4.-1 (swiveling in the purlin)
Fig. 5.4.-2 (hammering in the fastening device)
1.
2.
1.
2.
Swivel the module-bearing rail
into the pre-assembled fastening
plates on the girder assembly.
NOTICE
Please note that the module-bearing rail must be mounted at a 90° angle to the girder assembly to
safeguard that the modules are correctly supported. In the case of an imprecise mounting, the modules
could fall down in the worst case.
CAUTION
•
Wear adequate protective equipment, especially a hard hat, when mounting the module-bearing rails!
•
Secure all parts that need to be fastened against slipping!
•
Use appropriate auxiliary devices to handle heavy loads and ask your co-workers for help!
•
Keep the work area clean to avoid falls!
•
Never walk under suspended loads and secure objects and tools against falling down.
Use a zinc dust primer to coat the
top 3 cm of the module-bearing
rails.
3.
ATTENTION
The fastening plates have slotted holes for fi ne adjustment and have to be readjusted, if required.
Schletter Solar GmbH – Alustraße 1 – 83527 Kirchdorf
Mounting instruction
FS UNO
with SRF Foundation Posts
| 2016.09 V.00
4
