Schlage CO-250, Руководство пользователя

Страница: 6 / 12

6 • Schlage • CO-250 user guide
Test lock operation
If you encounter problems while performing any of the following tests, review the installation
guide and correct any problems.
Mechanical test
1. Rotate the inside lever or depress the push bar to open the door. Operation should be
smooth, and the latch should retract.
2. Insert the key into the keyway and rotate the key and the outside lever to open the door.
Operation should be smooth, and the latch should retract. The Schlage button will light
solid green until the key is released and the latch is extended.
Test in factory default mode
1. For locks with a keypad, press any number key. The lock will beep and the Schlage
button will blink red.
2. The Schlage button will blink red twice when a credential is presented and the lock is in
factory default mode, and has no access programming.
3. For locks with keypads, enter the default PIN (13579 and “#”) to verify access. The
Schlage button will blink green, a beep will sound, and the door will unlock for the preset
relock delay period. After the relock delay period, the lock will relock and the Schlage
button will blink red. If the lever retracts and holds the latch through the relock delay
period, then the Schlage button will light green until the lever is released.
Test in normal operation mode
1. Present a valid credential. The Schlage button will blink green, a beep will sound and
the door will unlock for the preset lock delay period. The lock will re-lock after the relock
delay period and the Schlage button will then blink red. If the lever retracts and holds the
latch through the relock delay period, then the Schlage button will light green until the
lever is released.
2. If an invalid credential is presented, the Schlage button will blink red, a beep will sound
and the door will not unlock.
Normal lock operation
After the lock has been programmed, present credentials to operate the lock as follows:
Credential type Action
Credential Present credential to reader

Green blink and access granted
+ PIN credential
P PIN credential to reader

Green blink and access granted
1 If the PIN is entered incorrectly, press “ * ” to start over.