Scheppach 5904410901, Перевод оригинального руководства пользователя

Страница: 27 / 124

Motor braking unit
The is fitted with an automatic motor braking unit
which becomes effective as soon as the driving mo -
tor is switched off.
10. Operation
m
ATTENTION! Observe the safety instructions
before the commissioning!
The device may only be commissioned when the
protective and intake equipment is fully mount-
ed!
Operating panel (Fig.1)
• On-switch (10): The shredder is started when this
button is pressed.
• Off-switch (10): The shredder is stopped when this
button is pressed.
Working with the shredder
You shred wilting garden waste and branches
that have been stored for several days.
• Connect the shredder to the power supply.
• Put the shredder into operation using the on-switch
(10).
• Fill the shredding material into the filling funnel and
the material is then drawn in.
• Allow the shredder to fully shred the shredding
material introduced before you introduce any
new materials.
• Do not use your hands to push down the shredding
material, only use a specialist tool for this or other
shredding material
• Switch off the shredder after the work has been
completed and disconnect this from the power sup-
ply.
Changing and grinding the knife
m
WARNING ! Await complete standstill of cut-
ter. Before working on cutter, remove mains
plug!
The reversible steel blade can be used on both sides
and can be replaced quickly and easily.
Caution when working: There is a danger to fingers
and hands. It is extremly important to use only well
sharpened knives.
So please note:
A blunt knife impairs cutting performance and makes
work difficult.
A sure sign of a blunt knife is a reduction in automatic
pull. Engine heats up, overload protection triggers.
Replacing the blades (Fig. 6-7)
First open the housing by releasing the locking screw
(2). Then fold the upper section of the housing out -
ward (Fig. 6).
Then remove the aluminium cover by releasing the
eight Phillips screws (Fig.7).
The knife disc remains mounted, (Fig. 7)
With either a small screwdriver or a nail, remove de -
bris from the inner hexagon socket of the blade fas -
tening screw. The T-handle pin-key has to completely
reach into the inner hexagon socket in order to un -
screw the screw. The screws are tightly screwed in.
In mounting the blade, lubricate the flat head screws
and tighten well.
Blade removal
The blade, as well as the blade surface area of the
cutting disc, must be cleaned of hardened debris
material. Upon reinstallation, the blade disc must be
mounted exactly as before.
Sharpening the blade
In resharpening the blade, pay close attention to
maintaining an even blade-diameter so as to avoid an
imbalanced blade.
The new blade has a width of 30 mm. In resharpening
the blade, a maximum of only 4 mm may be removed
from each cutting edge.
11. Maintenance
When performing maintenance and cleaning work,
turn off the motor and pull the plug!
Do not spray the machine with water!
Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the fol -
lowing parts are therefore also required for use as
consumables.
Wear parts*: shredder blade, knife roller, cutting
plate, feeding device
* Not necessarily included in the scope of delivery!
Motor and switch
Fitting, repair and maintenance work on the electric
unit can only be carried out by a qualified electrician.
When returning the motor, always send the entire mo -
tor apparatus with the switch.
Please provide the following information in the event
of any enquiries:
• Type of current for the motor
• Machine data - type plate
• Machine data - type plate

www.scheppach.com /

service@scheppach.com /

+(49)-08223-4002-99 /

+(49)-08223-4002-58
GB
| 27