Scheppach 5904410901, Перевод оригинального руководства пользователя

Страница: 28 / 124

12. Electrical connection
The installed electric brake motor is ready to be put
into operation. The connection meets the relevant
VDE and DIN requirements.
The electric brake motor causes the disc blade to
come to a near immediate standstill after the machine
has been turned off.
Firring, repair and maintenance work on the electric
unit can only be carried out by a qualified electrician.
Damaged electrical connection cables
Insulation damage often occurs with electrical con -
nection cables.
Some causes are:
• Pressure points, especially when electrical connec -
tion cables are run through window or door cracks.
• Kinks caused by improper handling or mowing of
the electrical connection cables.
• Cuts resulting from being run over
• Insulation damages caused by pulling the cable out
of wall sockets.
• Cracks resulting from aging of the insulation.
Such insulation damaged electrical connection ca-
bles cannot be used and are, as a result of their insu-
lation damage. LIFETHREATENING !!
Check the electrical cable connections on a regular
basis. When checking the cables, make sure that the
cables are not stuck to the electrical network.
Electrical cable connections built with seal contacts
must meet the relevant VDE and DIN requirements.
Only use electrical cable connections with a rating
of at least H 07 RN or a rubber sheathed cable. The
type rating of the connection cable must be printed
on the cable.
Single-phase motor
• The single-phase motor turns in the direction
shown in Fig. 7.
• The mains voltage must comply with the specifica -
tions on the motor nameplate.
• Extension cables up to 25 m in length must have a
cross section of at least 1,5 mm² , above 25 m at
least 2,5 mm²
• Mains fuse protection is 10 Amps slow-blow.
In accordance with safety regulations, the motor is
equipped with a switch featuring an integrated pro-
tective circuitbreaker, which cuts off the current in the
event of overload.
Overload may be caused by the following:
• longer-duration blockage of the knife disc
• alternately switching on/off of the motor in rapid
succession. In the event of a blocked knife disc, re -
move the cause to the overload. Disconnect the
mains plug .
After a short cooling-off time, switch back on the mo -
tor.
13. Disposal and recycling
The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The equip -
ment and its accessories are made of various types
of material, such as metal and plastic. Defective com-
ponents must be disposed of as special waste. Ask
your dealer or your local council.
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical
and electronic equipment (WEEE). This product must
be disposed of at a designated collection point. This
can occur, for example, by handing it in at an author -
ised collecting point for the recycling of waste electri -
cal and electronic equipment. Improper handling of
waste equipment may have negative consequences
for the environment and human health due to poten-
tially hazardous substances that are often contained
in electrical and electronic equipment. By properly
disposing of this product, you are also contributing to
the effective use of natural resources. You can obtain
information on collection points for waste equipment
from your municipal administration, public waste dis -
posal authority, an authorised body for the disposal of
waste electrical and electronic equipment or your
waste disposal company.

www.scheppach.com /

service@scheppach.com /

+(49)-08223-4002-99 /

+(49)-08223-4002-58
28 | GB