www.scheer-heizsysteme.de
heater to move®
general operating instructions
CE marking Corresponding to existing
EC directives
Technical changes reserved!
tested safety
transport and storage
•
Do
not
lift
and
lash
the device by the
fittings
•
The device must be stored
dry, dust-protected
and
frost-free
•
Disconnect
from
power source
for storage
•
Store only when
completely emptied
This ensures that no damage is caused to the device during transport or storage
assembly
•
In
outdoor
areas� level and stable ground must be ensured
•
Lock
the brakes to prevent rolling away
Disposal of old equipment
At the end of its service life the device has to be disposed of in accordance with national regulations.
It is recommended to contact a company specializing in waste disposal or contacting the disposal
department of your commune.
WARNING!
To prevent misuse and the associated dangers� make your old equipment unusable before disposal. There-
for disconnect the device from the power supply and remove the power cable from the device. To dispose
the device� observe the regulations applicable in your country and in your commune.
WARNING!
Danger due to electrical current!
The device may only be operated on properly installed single sockets with protective contact.
Do not disconnect the mains cable from socket by pulling the cable� always touch the housing of
the mains plug.
The MH-heating systems are approved for the use of „diesel“ and „heating oil“. Any other type of fuel for
operating have to be in advance approved by the manufacturer SCHEER. The heaters are designed for 230 Volts.
The connection in the vehicle has to be fed from the battery of the vehicle via an inverter approved in road traf-
fic within the scope of the ECE Regulation. Alternatively� the heater can also be done via a 230V direct supply
(for example: direct supply of the campsite).
9
