Counter Installation:
1) Unpack the counter, remove the black plastic mounting
halves and set them aside. Remove the protective film
covering
the counter face.
2) Re-install the two black plastic mounting halves onto the
counter.
3) Install the counter into the machine cover with the four
solder pins to the left side as shown (fig’s 1 & 3). Note that
there is a small plastic tab on each half of the mounting that
has to gently be pried outward to secure the counter.
4) Insert the tip of a small flat head screw driver behind each
edge of a tab and pry (fig 1).
Circuit Board Installation:
1) (fig 2) Install a nut onto
each toggle switch. Rotate
the nut all the way to the
bottom of the switch.
2) Install a lock washer on top
of each nut.
3) Mount the circuit board to
the cover by inserting the
toggle switches through the holes in the cover. Note the alignment of the circuit
board as shown (fig 3).
4) Note that the toggle switches have a slot or keyway down their
threaded surface (Fig 4). Install a small tabbed flat washer (tabs should
face away from the surface of the cover) and a nut on the toggle
switches and using a 10mm socket or wrench tighten the nuts to
mount the circuit board.
Fig 1
Fig 3
Fig 2
Fig 4
