- 4 -
ASSEMBLY INSTRUCTIONS
1.
Attach the fold bars to the legs.
Parts: two pairs of legs, 4
–
fold bars, 4
–
3/16" x 1-1/4"
carriage bolts, 8
–
3/16" washers, 4
–
3/16" lock nuts.
On the outside legs, the fold bar is installed on the side of
the leg that faces the inside of the loom, in the upper hole.
On the inside legs, the bar is installed on the side of the leg
that faces the outside of the loom. Make sure to orient the
fold bars as shown in figure 1.
Insert the carriage bolt into the square hole on the fold bar.
Align the square part of the carriage bolt just under the
head of the bolt with the square hole in the fold bar. Place a
washer on the bolt, insert the bolt into the leg, place anoth-
er washer on the bolt, and secure with a lock nut. Repeat
this process for all legs.
Note: The brake release pedal come shrink wrapped to the
right outside leg, we suggest leaving it wrapped (and out
of your way) until step 19
Figure 1 - ATTACH FOLD BArS TO rigHT iNSiDe AND OuTSiDe LegS
square hole in fold bar
Figure 1A - HArDWAre TO ATTACH THe FOLD BArS
Figure 2 - ATTACH CASTLe SiDeS TO LegS
1-1/4" carriage bolt
use the upper hole
on the outside legs
3/16"
washer
3/16" lock nut
fold bars
outside right leg
inside right leg
1-1/4"
carriage
bolt
fold bar
3/16"
washer
3/16"
washer
3/16"
lock nut
leg
2.
Attach the castle sides to the legs.
Parts: the two castle sides, 2
–
1/4" washers and 2
–
5/16"
lock nuts.
Place the legs so that the bolt holding the legs together is
extending upwards. Put the bolt through the hole in the
castle side, place a washer on the bolt, and secure with a
5/16" lock nut.
insert bolt in legs
through hole in
castle sides
right legs
left legs
left castle side
right castle side
