Scantronic 8136UK-50, Инструкция по установке и эксплуатации

Страница: 40 / 44

40 of 44 496339 Issue 4
User 00 The Installer or Engineer.
User 96 The central station when it carries out a remote
reset.
User 97 The control panel when it performs an internal
check (watchdog).
User 98 Any keyswitch.
User 99 <Downloader> when it connects to the system.
Operating the System
Users can set and unset the system from a keypad using one of the following
key sequences:
In order to: Key in: The system will do this:
Set the system ACCESS CODE + ENTER Exit tone starts. Leave
premises. System sets the
highest security Level.
See why system will A (repeat to see all messages) Display shows reasons for
not set. (Display shows stop. Check detector
“Setting Stopped”)) zones listed in display. Try
to set system again.
Turn the system off ACCESS CODE + ENTER Display shows time and
date. System is ready to
use.
Set individual Level ACCESS CODE + LEVEL KEY + ENTER Part sets the system.
Turn individual level off ACCESS CODE + LEVEL KEY + ENTER Display shows time and
date. System is ready to
use.
Set individual area ACCESS CODE+LEVEL KEY+AREA NO.+ENTER
Switch off the Bells ACCESS CODE + ENTER Bells and sounder cease.
The display shows first
detector zone to alarm.
Read log ACCESS CODE +MENU + 9 + Displays the events it has
ENTER + ENTER recorded. Press A to see
earlier events, Press B to
see later events
Reset system ACCESS CODE + ENTER Display shows time and
date. System is ready to
use.
Note: When a user has authority to set more than one Level, but does not
specify which Level to set, the system chooses the first Level in each Parti-
tion that the user has authority to set. For example: a user has access to
Partitions 1 and 2. Partition 1 can be set by Level A (Areas 1 and 2) and
Level B (Area 1). Partition 2 can be set by Level C (Areas 3 and 4) and Level
D (Area 3). If the user keys in [Access Code] + [Enter] then the system sets
Level A and Level C (equivalent to Areas 1, 2, 3 and 4).
installer Setting 8136