30
There are ventilation holes around outside of the hob. YOU MUST
ensure these holes are not blocked by the worktop when you put the hob
into position.
l
Be aware that the glue that join the plastic or wooden
material to the furniture, has to resist to temperature
not below 150
℃
, to avoid the unstuck of the paneling.
l
The rear wall, adjacent and surrounding surfaces must
therefore be able to withstand an temperature of 90
℃
.
9.2 Before installing the hob, make sure
that
•
The work surface is square and level, and no structural members interfere
with space requirements.
•
The work surface is made of a heat-resistant and insulated material.
•
If the hob is installed above an oven, the oven has a built-in cooling fan.
•
The installation will comply with all clearance requirements and applicable
standards and regulations.
•
A suitable isolating switch providing full disconnection from the mains
power supply is incorporated in the permanent wiring, mounted and
positioned to comply with the local wiring rules and regulations.
•
The isolating switch must be of an approved type and provide a 3 mm air
gap contact separation in all poles (or in all active [phase] conductors if the
