SawStop TGA-GA48, Руководство по установке, Страница: 18 / 28

16
SLIDING CROSSCUT TABLE INSTALLATION
Slide the miter gauge bar (249) into the T-slot on the sliding table top farthest from the blade, as shown in 17.
Fig.14 . For full cutting capacity, the miter gauge bar should be positioned flush with the front edge of the
sliding table. Use a 5mm wrench to turn the reverse-thread fasteners (248) at the front and rear of the miter
gauge bar COUNTERCLOCKWISE to lock the miter gauge bar in place.
Use a 5mm allen wrench to slightly loosen the miter gauge from the crosscut fence as shown in 18. Fig. 15 . Do not
loosen the miter gauge screws more than 1 ½ full turn . With the blade guard installed, raise the saw blade to
the highest elevation and tilt it to 45 degrees. Slide the crosscut fence to the right until the right side of the crosscut
fence is about 2 inches from the left side of the blade guard. Retighten the screws.
mounting the sliding Crosscut table to your saw:
Fig. 14
Fig. 15
For Mounting Configurations With the Left Extension Wing, Follow Steps 17-19