SawStop TGA-GA48, Руководство по установке, Страница: 11 / 28

9
SLIDING CROSSCUT TABLE INSTALLATION
If your saw is mounted on the stand, it is necessary to create a 2” diameter hole in the rear panel 13.
of the stand. The center point of the hole should be located as shown in Fig. 3 . SawStop recommends using
a 2” hole saw to form the hole in the rear panel. Finally, snap the supplied 2” grommet into the hole and feed
the cord from the motor through the grommet then reconnect it with the motor power cord.
Fig. 2
Fig. 3
Fig. 1