SawStop TGA-GA48, Руководство по установке, Страница: 17 / 28

15
SLIDING CROSSCUT TABLE INSTALLATION
Remove the T-bolt (229) from the Crosscut Fence Lock Knob and insert the threaded shaft of the T-bolt up 15.
through the slot on the fence as shown in Fig. 12 . Pivot the fence clockwise and slide the T-bolt into the T-slot in
the left side of the sliding table top. Place the plastic washer (228) on the T-bolt threaded shaft and then screw
on the crosscut fence lock knob. Do not tighten the lock knob at this time.
Use a 5mm allen wrench to slightly loosen the miter gauge from the crosscut fence as shown in 16. Fig. 13 .
Do not loosen the miter gauge screws more than 1 ½ full turn . If necessary, slide the fence left or right
to align the arrow on the miter gauge with the indicator on the fence for your saw type (ICS/PCS/CNS).
Retighten the screws, but not the lock knob. Now skip to step 20.
mounting the sliding Crosscut table to your saw:
Fig. 12
Fig. 13