SawStop TGA-GA48, Руководство по установке, Страница: 12 / 28

10
SLIDING CROSSCUT TABLE INSTALLATION
Set out the front rail, rear rail, and main tube. ( w/ 30” TSA-SFA does not have a front rail) 1.
Mark the front rail, rear rail, and main tube, measuring from the left end. Refer to the table below for the 2.
correct measurements.
Use a metal cutting band saw to cut the front rail, rear rail, and main tube at the marks made in the previous 3.
step.
Remove any burrs or sharp edges with a file. Remove the plastic end cap from the cut off portion of the main 4.
tube and install it on the new left end of the main tube.
Install the front rail, rear rail, and main tube as you normally would when assembling your table saw, using the 5.
instructions provided with your saw.
For saws only, follow steps 11-13 on page 8. For and saws, no further modifications are 6.
needed.
modifying your table saw:
unassembled saw
If your table saw is not assembled, follow these instructions in place of the instructions on Page 8 for modifying your saw rails
before assembling your table saw and attaching your Sliding Crosscut Table.
To orient the tube properly, ensure the ruler is right side up when you are facing the
tube. Then, measure and cut from the left end.
Using other types of saws (such as a circular saw) can generate enough heat to blister
the powder coating. It is stongly suggested that you use a metal cutting band saw only.
Front Rail Fence System Main Tube Rear Rail Front Rail Main Tube Rear Rail
30” (TSA-SFA)
30” (TSA-PFA)
36” (TGP-36)
52” (TGP-52)
36” (TGP2-36)
52” (TGP2-52)
30” (TSA-PFA)
36” (TGP2-36)
52” (TGP2-52)
36” (TGI-36,
CBF-36)
52” (TGI-52,
CBF-52)
13 5/8
13 5/8
13 5/8
13 5/8
13 5/8
12 5/8
12 5/8
12 5/8
10 3/4
10 3/4
13 1/4
13 5/8
13 5/8
13 5/8
13 5/8
13 5/8
12 5/8
12 5/8
12 5/8
10 3/4
10 3/4
10 1/2
12 3/8
12 3/8
13 5/8
12 3/8
12 3/8
11 3/8
11 3/8
11 3/8
10 3/8
10 3/8
1 1/4
1 5/8
1 5/8
1 5/8
1 5/8
1 5/8
5/8
5/8
5/8
3/4
3/4
3/8
3/8
5/8
3/8
3/8
3/8
3/8
1 5/8
1 5/8
1 5/8
1 5/8
1 5/8
5/8
5/8
5/8
3/4
3/4
ICS
PCS
CNS
Without Left Wing Installed
Cutting Point from Left End
With Left Wing Installed