SawStop TGA-GA48, Руководство по установке, Страница: 14 / 28

12
SLIDING CROSSCUT TABLE INSTALLATION
With the help of at least one other person to support the weight, turn the sliding table assembly over and 3.
position it against the side of the saw table.
Adjust the height of the sliding table to approximately match the saw table by turning the foot pads on the 4.
bottom of the leg assemblies.
Visually align the mounting holes in the side of the sliding table assembly with the holes in the side of the saw 5.
table and then mark the set of holes to be used. See Fig. 6 for saws, or Fig. 7 for saws.
Pull out the sliding table lock knob on the underside of the sliding table assembly and rotate it 90 degrees to 6.
unlock the sliding table. Then slide the table top toward the front of the saw to expose two of the mounting
holes, as shown in Fig. 8 .
mounting the sliding Crosscut table to your saw:
Fig. 6
Fig. 7
Fig. 8
PCS and CNS saws have 4 mounting holes.
ICS saws have 3 mounting holes.
ICS Model
Shown
Flush
Flush
Standard
Standard