SawStop TGA-GA48, Руководство по установке, Страница: 16 / 28

14
SLIDING CROSSCUT TABLE INSTALLATION
Place the two M8 T-bolts (109) from the Auxiliary Hardware Pack through the holes in the side of the 13.
extension table. Loosely install the flat washers (108) and lock nuts (110) on the T-bolts. Slide the heads of the
T-bolts (109) into the T-slot on the outside edge of the sliding table, and then tighten the nuts (110) to secure
the extension table in place. For most operations, position the extension table so that it is flush with the front
edge of the sliding table top, as shown in Fig.10 .
Slide the miter gauge bar (249) into the T-slot on the sliding table top nearest the blade, as shown in 14. Fig. 11 .
For full cutting capacity, the miter gauge bar should be positioned flush with the front edge of the sliding table.
Use a 5mm wrench to turn the reverse-thread fasteners (248) at the front and rear of the miter gauge bar
COUNTERCLOCKWISE to lock the miter gauge bar in place.
mounting the sliding Crosscut table to your saw:
Fig. 10
Fig. 11
For Mounting Configurations Without the Left Extension Wing, Follow Steps 14-16