www.sawo.com | [email protected]
Pidätämme oikeuden muutoksiin.
Subject to change without notice.
STN_ML_(En0218)
Code
Problem
Solution
E6
E7
E8
E9
E10
E11
E12
E13
Check that the drain valve is not blocked. Clean
the level probes.
If no problem can be found, contact the retailer.
Check that water supply is open and there is
enough pressure. Check solenoid valve. Clean
level probes.
If no problem can be found, contact the retailer.
Clean level probes. If no problem can be found,
contact the retailer.
Check that water supply is open and there is
enough pressure. Check solenoid valve. Clean
level probes.
If no problem can be found, contact the retailer.
Check that the drain valve is connected and not
blocked. Clean the level probes.
If no problem can be found, contact the retailer.
Check the RJ12 cable. If the area where cable
is located has many other cables, it can cause
EMC problems.
If no problem can be found, contact the retailer.
Contact qualified electrician or maintenance
personnel before using the steam generator
again.
Dip switch setting is incorrect. Check dip
switch settings.
Check RJ12 for loose contact. Replace RJ12.
If no problem can be found, contact the retailer.
Water level too high and
operation not permitted.
Water level too low and
operation not permitted.
Illogical combination of
water level measurements.
Fill failure.
Drain failure.
Communication failure.
Temperature is greater
than the maximum
temperature.
No master steam
generator connected.
