Sawn Craft Zero 32 Manual
4/18/16
7
6)
Make glue hinges. Pin to the building board each of the hinged parts, with bevel cut down against
the building board. Locate the parts with the mating surfaces gently touching. Run the smallest
possible bead of foam glue along each seam. Run a finger along each seam to push the glue
between the mating parts. Blot up excess glue with a paper towel. Let dry at sufficiently for the
glue to fully cure. Leaving the parts overnight is ideal for the strongest and most true bond.
BUILDING TIP: Keep small wipes handy to remove excess glue. Glue outside the joint adds weight, but
does not add strength. To get a pile of these wipes, lay four paper towels together and cut in half
repeatedly. Four paper towels cut to roughly 2x2 inch squares yields 64 very handy "micro wipes."
