9
10. ATTACHING THE FAN
BLADES
Caution:
Remove 5 rubber packing
mounts and discard before installation.
Step 1
Attach the blade to the blade
bracket using the screws and fiber
washers as shown in Figure 19. Start screw
into bracket. Repeat for the two remaining
screws.
Step 2
Tighten each screw. Make sure the
blade is straight.
Step 3
Fasten blade assembly to motor
using the screws supplied. (Fig. 19)
Figure 19
Figure 20
Screws
Blade
Blades bracket
Screws
Fiber
washers
11. INSTALLING THE
LIGHT KIT
NOTE:
B e f o r e s t a r t i n g i n s t a l l a t i o n ,
disconnect the power by turning off
the circuit breaker or removing the
fuse at fuse box.
Step 1.
Remove the 1 of 3 screws from
the mounting ring and loosen the other
2 screws. (Do not remove)
Step 2.
Raise and hold the light kit close
to the ceiling fan and proceed to do the
wire connections. Connect the white
wire connectors from the light kit and
fan, follow the same procedure with the
black wire connectors. (Fig. 20)
Step 3.
Place the key holes on the light
k i t o v e r t h e 2 s c r e w s p r e v i o u s l y
loosened from the mounting ring, turn
light kit until it locks in place at the
narrow section of the key holes. Secure
by tightening the 2 screws previously
l o o s e n e d a n d t h e o n e p r e v i o u s l y
removed. (Fig. 20)
Mounting ring
Connection plugs
Light kit
Screws
