6
6. INSTALLATION OF
SAFETY SUPPORT
An additional safety support is provided to
prevent the fan from falling. Secure the
safety cable to the ceiling joist with screw
and washer, as illustrated in Figure 11.
7. MAKE THE ELECTRIC
CONNECTIONS
WARNING:
To avoid possible electrical
shock, be sure electricity is turned off at
the main fuse box before wiring.
NOTE:
This remote control unit is equipped
with 16 code combinations to prevent
possible interference from or to other
remote units. The frequency switches on
your receiver and transmitter have been
preset at the factory. Please recheck to
make sure the switches on transmitter and
receiver are set to the same position, any
combination of settings will operate the
fan as long as the transmitter and receiver
are set to the same position. (Fig. 12)
Step 1.
(Fig. 13) Insert the receiver into
the mounting bracket with the flat side of
the receiver facing the ceiling.
Step 2.
(Fig. 14 & 15) Motor to Receiver
Electrical Connections: Connect the black
wire from the fan to black wire marked "TO
MOTOR L". Connect the white wire from
the fan to the white wire marked "TO
MOTOR N" from the receiver. Connect the
blue wire from the fan to the blue wire
marked "For Light" from the receiver.
Secure the wire connections with the
plastic wire nuts provided.
Hanger bracket
Safety cable
Figure 11
Figure 12
Figure 13
Code switch
ON
ON
Receiver
Hanger
bracket
