SP-5 Service Manual
9
Figure 9
Figure 10
ELEMENTS
Disassembly Instructions:
1. Disconnect main voltage.
2. Disconnect the electrical wiring.
3. Remove the “Air Box”.
4. Disconnect the element fixture.
5. Remove
the
element.
Assembly Instructions:
1. Assemble in reverse order according to steps 1-5
above.
NOTE: The maximum permissible torque to be
applied when tightening the electrical wire
connections is 10.6 in. lbs.. Use the double nut
underneath.
REQUIRED PARTS
QUANTITY
POSITION
Element 1
1
GRILL MOTOR
Disassembly Instructions:
1. Disconnect main voltage.
2. Remove the nut from the center of the hub.
3. Maximum torque is 9.5 in. lbs.. Use the radial slots
in the hub for holding.
4. Remove the connector wires on the motor plate.
5. Pull the motor plate with the motor backwards.
NOTE: Make sure the motor shaft follows along. If
not, there is a risk of losing the key between gear
box shaft and the motor shaft. In case the motor
shaft does not protrude through its bearing mount,
polish the part of the shaft that protrudes through the
bearing into the grill chamber.
In case polishing is not sufficient:
1. Remove the “Air Box”.
2. Remove the right inner wall.
3. Remove the three screws holding the bearing
mount.
4. The motor with its shaft and bearing mount can now
be withdrawn through the electrical compartment.
Assembly Instructions:
1. Assemble in reverse order according to steps 1-5
above.
NOTE: Check the direction of rotation, which is
supposed to be counter-clockwise seen from the grill
chamber side. The bearing is self-lubricating and
should not be lubricated. Check the measurements
between bearing shelf and the hub according to
Figure 15.
REQUIRED PARTS
QUANTITY
POSITION
Grill Motor
1
1