- 1 -
Thank you for purchasing the multiple measuring system model SK-5RAD-MR.
- This product is designed to measure dry bulb and wet bulb temperatures. Do not use it for other
purposes.
- Read this manual thoroughly before using. Keep the manual in a safe place for future references
whenever necessary.
Warning
The SK-5RAD-MR is not explosion-proof. Never use it in an atmosphere containing flammable
gases
.
Beware of explosion!
There is a risk of explosion. Take extreme care
.
Should you have any questions, please consult with the local store where the device is purchased
or with our service network.
Caution
■ Observe the following precautions to use this equipment correctly.
・
This is a precision equipment. Do not drop or apply impact or vibrations to it.
・
Never disassemble or modify the equipment. Doing so may result in failure.
・
Do not use this equipment in an area exposed to direct sunlight or near heaters. Doing so
may not only prevent correct measurement but could also result in failure or casing
deformation.
・
Do not use this equipment in an area subject to dust, flammable gas, explosive gas,
corrosive gas (SO
2
, H
2
S, etc.), etc.
・
Using this equipment in an environment with electrical noise may produce an unstable
display or an increase in measurement errors.
・
Do not use this equipment outside the measuring range. Doing so may result in failure.
・
This equipment is not waterproof and so must not be allowed to get wet.
・
Do not wash or wipe the equipment with solvents such as alcohol or thinner. If the
equipment becomes dirty, dip a gauze pad or soft cloth in warm water containing neutral
detergent, wring out the cloth, and then wipe the equipment with the cloth.
・
Do not forcibly pull, bend or bundle the cord or cable. Placing a heavy object on the cord or
cable, or heating or scratching it may result in failure.
・
Before turning on the power, make sure that the AC power cord and sensor cable have been
connected correctly, the sensor section has been set up and an SD memory card has been
mounted.
・
This equipment employs a small brushed motor. Be sure to turn off the power switch when
measurements are not being made. The service life of the motor is approximately 1,350
hours of operation. If this equipment is to be operated continuously for a long period of time,
