SASFORKS EXTREME AUTO PROCESSOR, Руководство пользователя

Страница: 17 / 63

SAS/op/proc/forks/op manuals/Ex/EXTREME MANUAL v16 .pub 3/24/2020
Page 17 © 2014-2020 S.A.S. of Luxemburg, LLC.
Failure to follow instructions and precautions noted in excavator manufacturer’s
manuals and this manual can result in serious damage to equipment and/or result
in injury or death.
Use caution while inspecting. Be aware of:
• Pinch points (and additional risks covered throughout this manual)
• High pressure hydraulic fluids or stored energy
• Location of other individuals in the work area
Prior to conducting inspection;
• Stick and Head assembly must be resting on firm level ground.
• Hold Down Assembly (HDA) must be resting on firm level ground.
• Excavator must be parked on firm level ground
• Excavator engine must be turned ‘off’
EXTREME AUTO PROCESSOR ATTACHMENT INSPECTION POINTS:
Head to stick fastening pins
• Check rotator to stick mount bolts
• Check pins for properly secured
• Check stick mount for cracks
Rotator
•
Check bolts fastening rotator to clamp body
• Check rotator for cracks
• Check for leaks or damage on hoses.
Clamp body
• Check for damaged pins, pin retention
hardware or misaligned pins
• Check clamp body for cracks
Claws & tips
•
Check claws for cracks
• Check claw tip bolts
Hold Down Assembly (HDA)
• Check all pins for properly secured
• Check HDA for cracks
• Check wire stripper for loose or missing bolts
Excavator x-frame inspection
•
Look from bottom up & or cracks around hinges
Operator cab
• Cab should have Roll Over Protection System
• Verify safety glass windshield in place
• Verify exterior steel guard is in place over front wind-
shield to protect operator.
Repair all problems before operation. Lock out / tag out excavator if defects present.
Repairs must only completed by authorized mechanic.
PRE-OPERATION CHECKLIST (PAGE 17)
SAS™ EXTREME™ AUTO PROCESSOR
READ & FOLLOW SAFETY INFORMATION IN ORIGINAL EXCAVATOR MANUFACTURER’S
OPERATOR, SAFETY AND SERVICE MANUALS. This checklist is limited to pre-operations
inspection focused on Extreme Head and Hold Down Arm assemblies (HDA).
Additional inspection points will be recommended in the excavator manufacturer manuals.
Single direct stick mount
s/n F5909 & up
Stick mount & stick adaptor
s/n under F5908