Page 24
Multilift Installation Guide
Part No. 000643, 26-m02-2013
Maintenance
The recommended maintenance schedule is provided below.
Maintenance Schedule
Verification by owner
Frequency
Verify general operation of the lift.
Every 2 months
Verify correct operation of the safety devices:
• Underpan safety switches
• Door contact
• Door lock
• Emergency stop
The lift should never run when these devices are activated or when the door is not
closed.
Every 2 months
Verification by technician ONLY
Frequency
Verify the following:
• General operation of the lift
• Operation of the underpan sensors
• Operation of the emergency stop
• Operation of the door and gate lock contacts. The lift should not run unless the
door or gate is closed and locked.
Every 6 months
Verify the safety components:
• Operation and alignment of the up final limit switch (activate by hand)
• Operation of the back-up nut safety switch; make sure it is in the proper location
(to the right of the load swtich).
• Operation of the load switch. Lower the platform to the ground using the hand
crank in order to release the load on the main nut. The lift should not run up until
you restore the load on the main nut by moving the platform up with the hand
crank.
• Operation of the up relays. Verify that neither of the two up relays gets stuck in the
activated position. Use a multimeter to verify that every N.O. contact is open
when the relays are not activated.
Every 6 months
Ensure that all hardware is tightened.
Every 6 months
Ensure that the main nut and the back-up nut are clean and free of any solid debris to
ensure proper action of the microswitches.
Every 6 months
Check the rollers (function and wear).
Every 6 months
Check the battery fluid level (optional system). Also check the voltage with the
charger unplugged (13 VDC unloaded and no lower than 10-11 VDC when running
up/down).
Every 6 months
Lubricate the acme screw, and upper and lower bearings using high-quality wheel
bearing grease.
Every 6 months
Содержание Multilift
