Sartorius Combics 2 CAIXS2, Руководство по эксплуатации

Страница: 71 / 180

Operating Instructions Combics CAIXS2 71
Operation
CTRL.SET
Activate SET control output 4.3
OUTPUT
“SET" output 4.3.1*
OP.READY
Ready to operate 4.3.2
OUTP.ACT
Port lines 4.4
OFF
Off 4.4.1
ALWAYS
Always on. 4.4.2
STABIL
On at stability 4.4.3
CHECK.RG
On within checkweighing range 4.4.4*
STAB.CHK
On at stability within checkweighing
range 4.4.5
INPUT
Parameter input 4.5
TAR.MN.MX
Min, Max, target value 4.5.1*
TARG.PER
Only target value with percent limits 4.5.2
TAR.A.PER
Target value with asymmetrical percent
limits 4.5.3
TAR.TOL
Target value with relative tolerances 4.5.4
AUT.PRNT
Automatic printing 4.6
OFF
Off 4.6.1*
ON
On 4.6.2
OK
Only values within tolerance 4.6.3
NOT OK
Only values outside tolerance 4.6.4
APP.ZERO
Checkweighing toward zero 4.7
OFF
Off 4.7.1*
ON
On 4.7.2
)
t
To save the setting, press the
)
key.
( (
...
t
To exit setup: Press the
(
key several times.
Display
The result of a measurement is shown either as a weight value or in relation to the
target.
Weight display:
The measured value line always shows the weight value, even if it
lies outside the tolerance range. The bar graph is displayed with symbols indicating
lower limit, target and upper limit. Weights are shown logarithmically from 0 up to
the lower tolerance limit, and linearly beyond that point.
Relation to target value
: As “Weight display" above, with the exception that:
–
LL
appears in the main display if the weight value is less than the lower limit
–
HH
is shown on the main display if the weight value is higher than the upper
tolerance limit.
Digital I|O Interface
The
Checkweighing
application supports the digital input/output interface.
The four outputs are activated as follows:
– Less than > red LED lights up
– Equal to > green LED lights up
– Greater than > yellow LED lights up
– Set.
The outputs can also be galvanically isolated using option A5.
Acoustic signal: An acoustic signal can be activated in addition to the green LED.
Setting: menu item 8.2.3.