Installation Instructions
Mortise Lock
IN100 Series
16 1-800-810-WIRE • www.sargentlock.com • A8190E
Copyright © 2016, 2020-2021, Sargent Manufacturing Company
, an ASSA ABLOY Group company
. All rights reser
ved.
Reproductions in whole or in part without express written permission of Sargent Manufacturing Company is prohibited.
1-800-810-WIRE • www.sargentlock.com • A8190E 17
02/28/21
Reader (24-pin)
Board-to-Board
Connector
Fully
tighten
6
Lock Installation continued
h. Secure the following connectors to their
respective terminals (Figure 9A, C):
CAUTION: Do not touch or allow debris to enter
connector contacts.
• Secure 4-pin DPS connector**
• Secure 10-pin lock body assembly connector
*NOTE: Optional 2-pin external
12-24VDC power connector.
IMPORTANT: Do not run wires through bottom hole in
plate - it will damage wires and controller connector.
Route wires around flange, do not route wires through
flange hole. (Figure 9A).
*Optional 12-24VDC Power
Remote Power Harness Wire Terminations
2-pin
Connector
Black
PS (-) Return
Red
PS (+) 12-24VDC
Ring Terminal
Green Earth Ground
Power Supply (PS) Required - UL Class 2
Filtered & Regulated, 12-24VDC, 1.0A
Ground
Lug
DPS (4-pin)
for 7900**
Lock
Body
(10-pin)
12-24VDC
Power*
*If 12-24VDC power harness
used, secure its ground (ring
terminal) here too
Fig. 9A
Fig. 9B
Fig. 9C
DPS (4-pin)
for 8200**
**Note different routing of Door Position Switch harnesses
i. When all connections have been
made, tuck excess cable into
wire hole on inside of door.
j. Secure mounting assembly while ensuring
proper alignment of outside reader and
tighten two (2) through-bolts on inside
of door to secure reader. (Figure 9B)
k. Secure 24-pin card reader con-
nector. (Figure 9C)
