Installation Instructions
Mortise Lock
IN100 Series
18 1-800-810-WIRE • www.sargentlock.com • A8190E
Copyright © 2016, 2020-2021, Sargent Manufacturing Company
, an ASSA ABLOY Group company
. All rights reser
ved.
Reproductions in whole or in part without express written permission of Sargent Manufacturing Company is prohibited.
1-800-810-WIRE • www.sargentlock.com • A8190E 19
02/28/21
For mortise locks with cylinders:
1.
Insert key into cylinder and rotate.
(Figure 23)
NOTE: There should be no friction
against lock case, wire harness or any
other obstructions.
2.
Check that key retracts latch.
NOTE:
Key should rotate freely.
3.
Throw deadbolt, if present. Check that
key retracts both deadbolt and latch.
4.
Try inside lever; ensure it retracts latch
and deadbolt, if provided.
5.
Present a valid credential* to unlock
outside lever; turn lever handle to
ensure latch retracts. (Figure 24)
NOTE:
Credential should approach
inscription on reader as indicated to
ensure credential is read properly. Do
not wave credential. (Figure 24)
*
Depending upon availability of access control
system either a (denied) red flash or a green
and lock motor cycle (access granted).
6
Lock Installation continued
12 Install inside cover (Figure 22)
a. Assemble cover by hooking top
edge on inside mounting plate.
b. Carefully press bottom of cover
toward door without pinching or
damaging wires.
c. Secure cover utilizing security allen
wrench (provided).
7
Operational Check
Inside
Cover
Security
Allen Screw
Fig. 12
Fig. 13A
Fig. 13B
