Installation Instructions
Mortise Lock
IN100 Series
IN100 Series
Mortise Lock
Installation Instructions
8 1-800-810-WIRE • www.sargentlock.com • A8190E
02/28/21
1-800-810-WIRE • www.sargentlock.com • A8190E 9
Copyright © 2016, 2020-2021, Sargent Manufacturing Company
, an ASSA ABLOY Group company
. All rights reser
ved.
Reproductions in whole or in part without express written permission of Sargent Manufacturing Company is prohibited.
Inside of
Door
DPS 4-Pin
Harness
Fig. 2A4
4. Install **Door Position Switch (DPS)
a. Push wire harness through raceway toward lock prep.
b. Push DPS firmly into place by hand.
Note:
DO NOT TAP SWITCH WITH ANY TOOL.
c. Install magnet into door frame.
Push firmly into place by hand.
See instruction
A7983
.
CAUTION: if DPS is not installed or is installed improperly,
door status monitoring features will not function.
**Only required with the 7900 lock body.
6
Lock Installation continued
2B Install 7900 Lock Body
1. Feed the wire harness into the mortise pocket and
through inside preparation hole (Fig. 2BB).
2. Carefully push the lock body into the pocket while
lightly applying tension to the wire harness.
Note: Do not pull the lock into the pocket using the harness alone.
Ensure that the wire harness is not pinched between the lock and the mortise pocket.
3. Insert (2) #12-24 screws into the lock body
(Fig. 2B) and tighten* with a screw driver.
*Do not fully tighten until cylinder and levers
are installed and properly aligned.
Fig. 2B
(2) #12-24
screws
Inside of
Door
Wire
Har-
ness
Ground
Wire
