1
On the ALARM SETTINGS screen, in [MOTION], select “DETECT”.
2
In [DURATION], select how long you want the alarm state to be retained when the motion
sensor detects motion and click
DETAIL
.
The detection area configuration screen appears.
5SEC, 10SEC, 15SEC, 20SEC, 30SEC, 45SEC, 1MIN, 2MIN, 3MIN, 4MIN, 5MIN
CC (Retains the alarm state as long as the motion alarm persists.)
The terminal will not accept subsequent alarm signals until the set duration expires.
The alarm state will be retained for at least 5 seconds even if the motion is instantaneous.
The configured duration value will be reset to the factory default value if you change any setting on
the ALARM SETTINGS screen while an alarm state is retained.
To switch the alarm detection method, in [MOTION ALARM], click the desired radio button.
3
Click
PTZ
to view the PTZ controller.
4
Use the controller to adjust the orientation of the camera lens while monitoring live video
displayed on the monitor.
5
Drag the mouse over live video/image to select the detection area.
While changing the orientation of the camera lens, you can apply up to 32 detection areas to anywhere within the
whole monitored area (five spots at the maximum for a single screen).
Each detection area will be given a number (1 to 32). The currently selected area is shown in yellow green.
Working with Administrator Configuration Screens 51/77
