Correction may not work for greater or smaller shakes than a given range of magnitude.
The sway correction function is temporarily disabled in the following conditions:
The camera is panning or tilting.
Switching between the color and the black-and-white modes is taking place by means of the
DAY/NIGHT function.
When the motion sensor detects any motion, the camera will follow the moving object.
Select “ON” and, in [SENSITIVITY], specify a detection sensitivity value for the sensor.
The higher the value, the lower the sensitivity.
Checking how the motion sensor works
Click
TEST
and you can verify how the camera follows the moving object. Correct the detection conditions as
required.
While the sensor is working, this button is labeled as
END
. To finish checking the motion sensor,
click the button.
The automatic pursuit function will not work in the following conditions:
The camera is moving in the automatic mode or by means of the preset function.
The camera is panning or tilting through manual operation.
Click
GO
to cleanse the contact point of the rotating section.
Once the cleaning is finished, the system will perform the initializing operation.
Periodical cleaning is recommended, because the contaminated contact point may lead to
deterioration of video quality and generation of noise.
Click
SET
for [PRESET POSITION SETTINGS] on the PAN/TILT screen to display the PRESET POSITION
SETTINGS screen.
On this screen, you can save the orientation of camera lens, the conditions of focus and zoom, and the operation
conditions as preset positions.
You can also use the PTZ controller to save such preset positions; however, this screen allows you
to specify more detailed settings.
Working with Administrator Configuration Screens 43/77
