Symptom
Cause
Solution
The unit ejects the disc.
The disc was inserted
Insert the disc with the label
upside down.
facing up.
The disc is extremely dirty.
Clean the disc.
There is condensation on
Leave the disc player off for an
the optical lens.
hour or so, then try again.
The compact disc does not
The volume control is
Turn up the volume control.
play when inserted into the
turned down.
unit.
The power connections are
Check the
and ground
not wired correctly.
c o n n e c t i o n s .
The CD cannot be loaded.
The shipping screw has
Remove the shipping screw.
not been removed.
No power.
The vehicle ignition is
Switch the ignition to the “ON” or
switched off.
position.
The fuse is blown.
Replace the fuse with another
OA fuse.
The unit does not work
The microcomputer has
Eject the disc, then insert it again.
properly (Eject, Load,
been affected by electrical
P l a y ) .
noise.
Press the RESET button.
The sound from the CD
The road surface is rough.
Wait for the road surface to
player skips.
improve before playing a disc.
The unit is not mounted
Install the unit securely. Be sure to
s e c u r e l y .
use the rear strap if the vehicle
does not provide support for the
rear of the unit. (See page 16)
The disc is defective.
Try another disc.
If it plays properly, the first disc
may be defective.
The disc is dirty.
Clean the disc as explained on
page 3.
No radio reception.
The antenna cable is not
Insert the antenna cable firmly
connected.
into the antenna jack on the unit.
The radio does not stop on
The signals are weak.
Select a station using manual
any stations when
tuning.
automatic tuning is used.
Function buttons do not
The unit must be reset.
Press the RESET button.
operate.
TROUBLESHOOTING
Sometimes a simple operational error or a mistake in the wiring can appear to be a problem with
the unit. Before having the unit serviced, refer to the troubleshooting chart below.
