Sanyo ECO G SGP-EW120M2G2W, Технические данные инструкция

Страница: 108 / 115

Separately Sold Parts
1. Outdoor unit related parts
F-2
(1) Exhaust extension kit (SGP-PEX560K)
(1) External dimension diagram
(2) Limitations when the exhaust pipe is extended
Observe the following limits when carrying out exhaust pipe extension work.
(3) Installing the exhaust extension kit
1) Disassemble the adaptor for the exhaust extension
a) Open the box, and check that it contains the following parts.
Exhaust extension adaptor and exhaust top assembly x 1
O-ring (P-70) x 1
Instruction manual x 1
b) Fully insert the exhaust top all the way into the exhaust extension adapter once.
c) Pull out the exhaust top in the direction of the arrow while pressing the stopper on the exhaust
extension adapter.
2) Remove the cap and exhaust top (standard parts)
a) Remove the cap (M5 screw) attached to the top of the outdoor unit.
b) Remove the exhaust top (M4 screws x 2) in the same way while taking care to not to dislodge the
exhaust pipe. (The exhaust top can be removed easily if you use lubricant and turn it during
removal.) The two M4 screws will be reused, so take care not to lose them.
c) Remove the existing O-ring from the exhaust pipe and attach the supplied O-ring.
The edge of the exhaust pipe is sharp, so be careful not to injure yourself when you perform this
step.
Limitations during installation work Limit value
Outdoor air temperature -5
°
C or more
Extension of exhaust pipe 5 m and 4 bends or less
Slope of the exhaust pipe Gradient of 3/100 or more (upward)
Figure 3
Figure 2
Figure 1