Click the camera's video.
The video image is now displayed in a single-screen layout.
Select a preset number by clicking.
The camera orientation has been set to the registered preset position.
Click the camera's video.
The video image is now displayed in a single-screen layout.
Click .
Deselect the Registration check box.
Select the preset number you want to delete.
The selected preset position has been deleted.
You can continuously execute a registered pattern of movements (movements according to a trajectory or command).
Click the camera's video.
The video image is now displayed in a single-screen layout.
Click .
The button is highlighted and the camera follows the registered pattern of movements only while the mouse button is held down.
Click any button other than
.
The camera stops following the registered pattern of movements.
You can monitor what's happening by moving the camera through two or more preset positions in the order of preset numbers.
Click the camera's video.
The video image is now displayed in a single-screen layout.
Click .
The button is highlighted and the camera patrols the preset positions only while the mouse button is held down.
During a patrol run, the preset number for the current position is highlighted.
Click any button other than
.
The camera stops patrolling the preset positions.
You can move the camera to and fro between the registered start and end points.
Click the camera's video.
The video image is now displayed in a single-screen layout.
Click .
The camera starts moving to and fro between the start and end points.
Click any button other than
.
The camera stops moving to and fro between the start and end points.
Instead of using the PAN/TILT controller, you can use the mouse to change the camera orientation.
Select a camera.
Select the [Mouse control] check box.
Now, you can use mouse to control the camera.
Click the left mouse button and move the mouse while holding down the left mouse button.
The camera orientation changes according to the mouse movement.
Use the [Speed] slider to adjust the mouse control speed.
If you are using a three-button mouse, clicking the center mouse button causes the camera orientation to change so that the clicked point appears at the center of the screen.
To perform manual recording in emergencies, follow the steps below.
You can record video images from all cameras simultaneously, regardless of the screen layout.
Click the Recording button (in white).
The digital video recorder starts recording as soon as you click the Recording button, with the following confirmation message.
1
2
1
2
Preset
3
4
1
2
Pattern
3
Pattern
1
2
P-run
3
P-run
1
2
A-run
3
A-run
1
2
3
1
20/182
ページ
2008/10/27
