Sanyo 1 852 351 85, Техническое и сервисное руководство

Страница: 73 / 164

7
Remote Control Unit (continued)
FAN SPEED selector button : The air conditioner automatically decides the fan speeds.
: High fan speed
: Medium fan speed
: Low fan speed
FLAP button Press this button either to select the setting of the airflow direction to the
auto. flap in each mode or one of the six possible positions manually or to
select the sweep function which moves the flap up and down automatically.
: Auto flap setting: If selected in a heating operation, the flap is set to
position (3) in the following chart. If selected in a cooling or dry
operation, the flap is set at position (7) in the following chart.
: The airflow direction can be set manually. (six positions)
: The flap moves up and down automatically.
When you press the FLAP button, the air flow direction will be changed one
by one as follows.
ON TIME/OFF TIME setting
buttons
No display: The timer does not operate.
: The air conditioner starts at the set time.
: The air conditioner stops at the set time.
NOTE
SWEEP
ECONOMY button
For details, see “5. ECONOMY Mode”. When you press this button in the
HEAT, DRY or COOL mode, the mark appears in the display, and the
remote control unit will automatically adjust the set temperature to save
energy.
CANCEL button
After using the TIMER ON button or TIMER OFF button to set the timer,
press this button to cancel the setting.
ACL button (ALL CLEAR)
Puts the remote control unit into pre-operation status. Always press
this button after replacing the batteries.
The remote control unit sends the temperature signal to the air conditioner regularly at five minute intervals.
If the signal from the remote control unit stops for more than 15 minutes due to the loss of the remote control
unit or other trouble, the air conditioner will switch to the temperature sensor which is built into the indoor unit
and control the room temperature. In these cases, the temperature around the remote control unit may
differ from the temperature detected at the air conditioner’s position.
NOTE
Jumper wire for address switching
• The address switch changes to prevent mixing of
signals from remote control units when two air
conditioners are installed next to each other.
For more information, please contact the dealer
where you made the purchase.
Back side of remote
control unit
(Cover removed)