Sanwa MT-R RX-493i, Руководство пользователя

Страница: 8 / 31

14 13
Before Driving A Car
Before Driving
A Car
Before Driving
A Car
14 13
1. Taking off an arm from servo
2. Turn on transmitter & receiver
3. Powered the servo to be
neutral position
4. Please place servo arm on 90 degree
as the picture. Please use SUB TRIM for
slight arrangement.
5. Place the servo on the RC Car.
*Servo arm angle depends on
EC Car. Please check and
follow RC Car manual.
Taking on servo arm before servo
does not make neutral position.
Servo arm will be neutral position
after turning on the servo.
This would be incorrect servo arm position
and it is caused to servo and car broken.
OK NG
No Operation
Right Operation Left Operation
REV Setting Requirement
Tire direction is right
Tire direction is left
No Operation
Right Operation Left Operation
Tire direction is right
Tire direction is left
Wanted to place servo arm in
car manual but cannot place
slightly different.
Arrange neutral position by
SUB TRIM setting.
Example of SUB TRIM Arrangement
Before Trim Adjustment After Trim Adjustment
Go straight
Automatically turning right or left
Steering
No Operation
HOW TO PLACE SERVO ARM
HOW TO SET REVERSE [REV]
HOW TO SET SUB TRIM [SUB-T]
SUB TRIM AND TRIM DIFFERENCES
●
Power the servo will be returned neutral position.
●
Turn on binded receiver and transmitter before taking on servo horn.
●
Be sure about transmitter Trim and Sub Trim are no setting (value is 0).
In case Trim and Sub Trim did not set 0, please set 0 for these setting.
●
Please place servo arm on center postion such as the below picture.
*Servo horn angle may not be 90 degree due to RC car type.
Please place servo horn to follow instruction manual of RC car.
● Please check
steering operation and tire direction are same after tacking on servo arm.
●
Please set REVERSE in case steering operation and tire direction are diffrerent. About REVERSE
setting please reffer p.22 in this manual.
●
In case servo cannot place correctly as 90 degree or RC Car manual instruction, please arrange neutral
position by SUB TRIM setting. About SUB TRIM setting, please refer p.22 on this manual.
● SUB TRIM is for neutral position and mainly used on the pit as taking on servo horn.
TRIM is for driving arrangement and mainly used while driving such as below picture. Please refer p.22 in
this manual.
*RC car did not go straight as accident.
TRIM is used for direction arrangement.