Sanwa MT-R RX-493i, Руководство пользователя

Страница: 4 / 31

6
Before Using
Before Using
5
Structure and the Standard of the Set
Structure
&
the Standard of the Set
6 5
MT-R (TX-4101)
MT-R RX-493i PC (Primary Component)
<
Ａ
>
<
Ｂ
>
<
Ｃ
>
<
Ｄ
>
RX-493i
●Please check items before use
Brake T1/+2 x each 1
Receiver Dust Cover x1
Bind Plug x1
Antenna Pipe x1
User Manual x1
Transmitter
Receiver
Servo
Accesories
MT-R (TX-4101)
366 g
2.4 GHz Spread Spectrum System
Digital display (Power Source Voltage Display)
AA BATT x4 (Corresponding VOLT: DC4.8 - 7.4 V)
Output Display
Product No.
Power Source
Weight
Modulation 26.0x23.2x14.0mm Size
RX-493i
DC3.7
～
7.4V
6.2 g
Product No.
Power Source
Weight
2.4GHz Spread Spectrum System Modulation
*Be careful with the input voltage.
If voltage above allowable voltage is inputted, the transmitter will be damaged.
<
Ａ
> Transmitter <
Ｂ
>
Receiver
Adjusting screw for
the trigger postion
Fixing screw of the trigger Fixing screw of the trigger
Trigger position gauge
Adjustable range: approx. 7mm
STRUCTURE OF THE SET
SET SPECIFICATION
ADJUSTING THE STEERING AND THROTTLE TENSION
ADJUSTING THE ADJUSTABLE TRIGGER
By inserting a hex wrench driver (1.5mm) to the place where the
arrow is pointing at in the illustration on the right and turning, you
can adjust the tension of the steering spring.
*The spring tension is the softest at the time when the product is
shipped out from the factory. As you tighten with a hexagon wrench
driver (1.5mm), the spring tension will be hardened.
Adujsting the Steering Tension
Adjusting the Throttle Trigger Tension
MT-R can adjust the tension of the steering/throttle trigger to match operation of the steering/throttle to the user’s preference.
By inserting a hex wrench driver (1.5mm) to the place where the
arrow is pointing at in the illustration on the right and turning, you
can adjust the tension of the throttle spring.
*Please do CALIBRATION when changing steering and throtte
tention. (p.48)
Loosen the fixing screws of the trigger on
the back of the transmitter. Then, adjust the
adjusting screw of the trigger position on the
back of the transmitter to set the trigger at
the position of your preference. When you
turn the adjusting screw of the trigger position
clockwise, the trigger position gauge moves to
the direction A. By turning it counter clockwise,
the trigger position gauge moves to the
direction B.
*The range of the trigger movement is 7mm.
If you turn the screw forcefully beyond the
range, it can cause malfunction. Once you set
the trigger position, tighten the fixing screw
and adjusting the trigger is done.
*Be careful with the direction of turning the
screw because the trigger position is set at the
furthest point of the A side at the factory.
MT-R can adjust the throttle trigger position fiting to the user’s hand size.
Adjusting the trigger position
*Setting Advice
Please fit trigger position to your finger naturally.
It would be smoother to operate braking.