3.7.3 SAS
“SAS”
can display SAS addresses.
Figure 3.7.3.1
3.7.4 Reset to default
“Reset to default”
allows user to reset controller to the factory default setting.
Figure 3.7.4.1
Reset to default value, the password is: 1234, and IP address as below.
Default IP address: 192.168.0.1
Default subnet mask: 255.255.255.0
Default gateway: 192.168.10.254
3.7.5 Config import & export
“Config import & export”
allows user to save system configuration values: export, and apply all
configuration: import. For the volume configuration setting, the values are available in export and not
available in import which can avoid confliction/date-deleting between two controllers. That says if one
controller already exists valuable data in the disks and user may forget to overwrite it. Use import could
return to original configuration. If the volume setting was also imported, user’s current data will be
overwritten.
Figure 3.7.5.1
1.
Import:
Import all system configurations excluding volume config.
2.
Import Logical unit only:
No system and volume configurations, import LUN configurations only.
3.
Export:
Export all configurations to a file.
Notice :
“Import”
will import all system configurations excluding volume configuration; the current configurations
will be replaced.
Advanced operation
45
