ASSEMBLY
The only tool you’ll need to assemble your
vacuum cleaner is a Phillips-head screwdriver.
Attach Handle to Vacuum
Fig. 1
Stand the vacuum upright and slide the
base of the Handle firmly into the grooves
at the top of the vacuum body.
Check to be sure the Handle is fitted to the
vacuum body. If there is a gap in front,
continue to push firmly until the Handle is
flush.
Fig. 2
Insert one screw from the assembly packet
into the existing hole in the back of the
Handle. Tighten securely with a
screwdriver.
Attach Vacuum Hose and Tools
Fig. 3
Position the hose collar on the back of the
vacuum as shown.
Attach the hose collar with two screws
from the assembly packet. Tighten
securely with a screwdriver.
Fig. 4
Line up the tabs on the base of the Twist ‘n
Snap™ Hose with the corresponding tab
notches on the hose collar as shown. Turn
the Twist ‘n Snap Hose to the left to lock
the hose into place.
Fig. 5
Grasping the Handle, slide the end of the
hose wand onto the suction intake
opening. Snap the hose into the Hose Clip.
NOTE:
The Powerfoot will not operate effectively
unless the hose wand is firmly attached to the
suction intake opening.
Fig. 6
Place the Crevice Tool inside the
Extension Wand and slide them into the
storage clip as shown.
Fig. 7
Snap the Combination Upholstery/Dusting
Brush Tool into the storage clip as shown.
8 www.sanitairecommercial.com
WARNING
Plastic film can be dangerous. To avoid danger of
suffocation, keep away from babies and children.
!
Fig. 1
Fig. 3
Fig. 4
Fig. 2
Fig. 5
Fig. 6
Fig. 7
ENGLISH
Hose Collar
Collar de la
manguera
Bague du boyau
