60
('
.5.2. REPLACING FILTERS FOR IN-LINE RECOVERY MODULES
('
.6. COILS
If you detect any problem in the coils and they need to be removed, loosen the bolts from
the panel where they are located, remove the panel and extract the coils. The coils are ins-
talled in slod for easy slide in and slide out.
('
.7. DAMPERS
• Make sure that the damper can open and close unrestrictedly and the (way) is unobs-
tructed.
• For manually controlled dampers fix the handle firmly to prevent the damper close while
the unit is running.
Access to fi lters is also possible through the lower panel. This requires lossen the screws
holding the lower panel located under the fi lters and remove it.
ATTENTION! Releasing the panel it could fall from heights with the risk of causing an acci-
dent. Pay special attention to this intervention.
After removing the panel, slide the fi lter down and replaced with the new fi lter.
To mount in reverse order follow the instructions above.
1. Remove the lower panel of
fi lter section
2. Remove the supports that
support the fi lters
3. Remove the fi lters
Содержание UTBS PRO-REG Series
