S&C Instruction Sheet 766-540 27
Updating Firmware
IntelliLink software includes an
Update
function to easily update the firmware.
NOTICE
Setpoint values and historical data stored in an IntelliRupter fault interrupter could
be lost during an update process . Always save the settings and a snapshot file
before updating the firmware .
NOTICE
Starting with firmware later than version 7 .3 .100, settings validation will be performed
at the beginning of the update process . If any validation errors are found, these
must be corrected before upgrading the firmware, otherwise the control settings
may not be retained . If this occurs after the upgrade is complete, settings can be
restored by uploading a saved IntelliLink software setpoint file to the control .
Follow these steps to update the firmware:
STEP 1.
Install the new IntelliRupter software on the computer. Refer to Instruction
Sheet 766-571, “IntelliRupter® PulseCloser® Fault Interrupter:
Software
Installation
.”
STEP 2.
Connect to the IntelliRupter fault interrupter using the Wi-Fi connection.
When IntelliLink software has opened automatically, in the
File
pull-down
menu click on the
Exit
option, and click on the
Leave Connected
button in
the Leave Wi-Fi Connection dialog box. See Figure 15.
STEP 3.
On the
LinkStart
screen, click on the
Download Utility
button. The Ilink
Loader dialog box opens. See Figure 16.
Figure 15. The Leave Wi-Fi Connection dialog box.
Figure 16. The IntelliLink Loader dialog box.
