S&C Instruction Sheet 766-540 15
Operating Levers and Indicators
Closing the Disconnect
Follow these steps to close the visible disconnect:
STEP 1.
Remove the tags or locks on the DISCONNECT operating lever and the OPEN/
CLOSE/READY lever, if applicable. See Figure 4 on page 9, and Figure 10 on
page 14.
STEP 2.
Insert a hookstick into the hole in the right section of the OPEN/CLOSE/READY
lever. See Figure 3 on page 9.
STEP 3.
Pull down on the right lever section. The three interrupters will open.
STEP 4.
Insert the hookstick into the left hole of the disconnect operating lever, above
the I. See Figure 10 on page 14. Pull down on the lever. The disconnect will
close.
STEP 5.
Insert a hookstick into the hole in the right lever section of the OPEN/CLOSE/
READY lever.
STEP 6.
Push up on the right lever section.
STEP 7.
Remove the hookstick and insert it into the hole in the
left lever section.
STEP 8.
To use the
First Closing
profile, pull down once on the left lever section. The
three interrupters will close.
To use the
Second Closing
profile, pull down twice on the left lever section (within
the time set for the
Manual Lever Closing Delay
timer).
STEP 9.
Check the interrupter OPEN/CLOSE indicators. See Figures 5 and 6 on page 9.
They should show the “I” indication.
